PSI Custom Supra Handbrake Handle Replacement Fitting Instructions

Thank you for the purchase of the Pro Spec Imports Custom Supra Handbrake Handle Replacement. Please note these instructions are only a guide. Please wear all appropriate safety equipment and follow at your own risk.

For installing on early model Supra (1993 - 1996) with leather type handbrake handle:

Installation Instructions:

1. First you need to remove your old handbrake handle leather, locate the stitching underneath. 
2. Then using a sharp craft knife carefully cut along the stitching 
3. Pull the stitching open. 
4. Peel the old leather back - Carefully cut around the handbrake button so the leather can be completely removed.
5. Remove any excess leather around the button.
6. Now your handbrake is ready to accept the new Pro Spec Custom handle: Slide on the new replacement handle and ensure it fits all the way to the end - tighten the grub screw underneath to hold it firmly in place.

Rubber handle on the late model 1996 - 2001 A80 Supra 

Installation Instructions. 

Please wear all appropriate safety equipment, follow at own risk

1. You only need to remove 'some' of the rubber ebrake handle to allow for the new replacement handle to slide over - You don't need to remove all of the rubber.
2. Start at the 'button' end of the rubber ebrake handle where its the largest, and carefully using a sharp razor blade you trim the rubber handle down until the new handle slides over, it doesn't take very much. 
3. Once you have the new handle sliding all the way down into position you can tighten the grub screw underneath until its firmly locked into place.